Digital Extender HS-66M Kullanıcı Kılavuzu - Sayfa 8

Anahtar Digital Extender HS-66M için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Digital Extender HS-66M 20 sayfaları. 6x6 hdmi matrix
Ayrıca Digital Extender HS-66M için: Kullanıcı Kılavuzu (20 sayfalar)

Sayfayı Yazdır
T
he functions of the switches are as follow.
•
Main power switch: matrix power on/off
•
Remote controller receiver: receive infrared ray from remote controller
•
Reset key: ini
tialize the matrix
•
Input key: select cha
•
Output key: select channel from 1 to
•
Create (CRE) key: change input/output channel
•
Preview (PRE) key: preview the status of current
•
Enter (ENT) key: save current selection
•
Cancel (C
AN) key: cancel current selection
•
EDID (EDI) key: read EDID data from display and then save data to matrix, whic
ports

3-2 Operation by Front Button

Input/output channel check:
Preview (PRE) button →
Input/output channel change
Create (CRE) button → Input # button set → Output ## button (Multiple selection) set
t
he connection of the channels are changed
* If you want to cancel, and then pre
Example: CH# 1 input to 1,2,3
Create -> Input 1 -> Output 1,2,3,4 -> Enter
S
ave (EDID) data
1, Disconnect the all input
2, Connect HDMI Matrix output to display directly (projector
3
, Power on both of HS-66M or HS-88M and Display (If you connect AV Receiver, disconnected display from the
Receiver)
3, E
DID (EDI) button → Select one of output
(on
e o
r multiple) → Enter (ENT): Read EDID data of display and save them
If t
he
ligh
t of the buttons on then just enter
4
, P wer
o
off all devices
5 Conn
,
ect all input cables
6,
Power on HDMI Matrix first.
7,
Power on all the Input sources and display (Power plug in and turn on set-top box)
-
#
: Select only on channel
-#
#: Sele
ct multiple channels
- All push b
uttons are on / off toggle (Light ON - Selected)
- If you use DV
I display, the EDID data should be saved to matrix
IR Remote Control unit
Create -
>IN
-># (ex: 1) -> OUT -># (ex: 1, 2, 3, 4) -> Enter
3-3 ro
P duct ID setting
•
Dip switch sets address for each matrix if many matrixes are used.
•
Dip switch sets in binary value.
Copyright 2007 RTcom USA., Inc.
nnel from 1 to 6 or 8
6 or 8
Input # button: present set channels are displayed in sequence
ss cancel(CAN) button.
,4 output with same picture
port cables on HDMI Matrix (The power set-top box should be unplugged (not sw. off)
# button (which is connected with display) → Input # button to be set
(ENT)
connection
, DVI monitor or AV Receiver),
to matrix.
first.
h is connected to output
→ Enter (ENT) button:
8