Cisco WS-G5486 Kurulum Notu - Sayfa 6

Anahtar Cisco WS-G5486 için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco WS-G5486 10 sayfaları. Gigabit interface converter module and small form-factor pluggable module
Ayrıca Cisco WS-G5486 için: Veri Sayfası (6 sayfalar), Kurulum ve Teknik Özellikler Kılavuzu (24 sayfalar)

Sayfayı Yazdır

Removing a GBIC

Figure 2

Plug

Step 4

Warning

modules when no cable is connected. Avoid exposure and do not stare into open apertures.

Step 5

Removing a GBIC

If you are removing a defective GBIC, perform these steps.

Step 1

Step 2

Step 3

Warning

6 Gigabit Interface Converter Installation Note

Installing a GBIC

WS-X5403

3 PORT GIGABIT ETHERNE

T SWITCHIN G MODULE

Slide the GBIC through the ﬂap covering the opening into the slot until you hear a click.

The click indicates the GBIC is locked into the slot.

Class 1 laser product

Invisible laser radiation may be emitted from the aperture ports of the single-mode ﬁber-optic

When you are ready to attach the network interface ﬁber-optic cable, remove the plug

from the GBIC and save the plug for future use.

Disconnect the network ﬁber cable from the GBIC SC connector.

Release the GBIC from the slot by simultaneously squeezing the two plastic tabs (one on

each side of the GBIC).

Slide the GBIC out of the Gigabit Ethernet module slot. A ﬂap drops down to protect the

Gigabit Ethernet module connector.

Ultimate disposal of this product should be handled according to all national laws and regulations.