Samsung 690 Series Kurulum Kılavuzu - Sayfa 27

Monitör Samsung 690 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Samsung 690 Series 50 sayfaları. Series 6
Ayrıca Samsung 690 Series için: Teknik Özellikler (36 sayfalar), Kullanıcı Kılavuzu (40 sayfalar), Kurulum Kılavuzu (48 sayfalar)

Sayfayı Yazdır

• The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10

seconds. All LEDs blink 5 times to acknowledge that this has been finished.

• The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The

LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If

the guest then touches another source button, the TV will change to the selected source and the corresponding LED will

be lit.

• After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between the TV and

the RJP.

• The following table shows the approximate time in seconds to switch from the TV to the input source, based on the

priority.

✎ Scenario 1: When no inputs are connected.

Source

HDMI

✎ Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.

Source

HDMI

✎ E.g. If the RJP has all its live sources AV, PC and HDMI connected, AV is viewed as the highest priority. If the RJP is

in HDMI mode, and a guest removes and reconnects the AV, the minimum time required to switch to the AV is 6.5

seconds.

• To connect audio (Ipod or Mp3), Music mode should be ON.

• A/V, PC and HDMI input sources are supported.

To Connect

2 Sec

0.7 Sec

3.9 Sec

Disconnect

To Connect

4.5 Sec

0.7 Sec

3.9 Sec

Total

2 Sec

6.5 Sec

1.4 Sec

7.8 Sec

English