Siemens 3SB5 Kullanım Talimatları Kılavuzu - Sayfa 3
Kontrol Ünitesi Siemens 3SB5 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Siemens 3SB5 14 sayfaları.
Sayfayı Yazdır
1
DETAIL B
DETAIL C
To remove Contact Block (5) from Holder (3), unlatch the snap-on feature by pressing the Shim (8) in the direction as
shown in DETAIL B
To remove Lamp Holder (7) from Holder (3), unlatch the snap-on feature by pressing the Shim (9) in the direction as
shown in DETAIL C
To mount and actuate the Contact Block (5) in the middle pole (Slot "56";Refer DETAIL A) of the Holder (3):
- Two numbers of Thrust Pads (11) should be press fitted into the slots of Sliders (12) of Selector Actuator (6).
- One number of Thrust Cap (13) should be press fitted into the pusher (14) of PushButton Actuator (1).
CAUTION: Mounting the Contact Block in the middle pole is not possible for Luminous version.
For Actuating Contact Blocks in the Middle pole of the holder:
11 .... Accessory Thrust Pad (3SB5912-0AN) for Selector Actuators
13 .... Accessory Thrust Cap (3SB5902-0AA) for PushButton Actuators
Step 1: Pass the Compact Pilot Light / Compact LED
(15) through the Cutout from the front into the
Ring Holder (16)
Step 2: Tighten the Compact Pilot Light / Compact
LED (15) with Ring Holder (16) by turning Ring
Holder (16) Clockwise
Mounting of 3SB5 Compact Pilot light / 3SB5 Compact LED
3
DETAIL B
5
3
8
5
3
DETAIL C
7
3
9
7
3
11
12
6
13
14
13
15
16
2
15
2
16