Cisco 730 Manuel - Sayfa 7

IP Telefon Cisco 730 için çevrimiçi göz atın veya pdf Manuel indirin. Cisco 730 16 sayfaları. Ip phones with multiplatform firmware
Ayrıca Cisco 730 için: Kullanıcı Kılavuzu (46 sayfalar), Yönetim Kılavuzu (36 sayfalar), Kurulum Kılavuzu (39 sayfalar), Kullanıcı Kılavuzu (44 sayfalar)

Your Headset

Note

You can't install firmware updates to your headset through the USB Adapter.

Procedure

Step 1

Plug in your USB Adapter to your preferred device.

Step 2

Turn on your Cisco Headset 730.

Step 3

On your device, select Cisco HS USB Adapter from the Bluetooth device list.

Pair the USB Adapter to Your Headset

You can re-pair your USB Adapter if you have erased your headset Bluetooth pairings or need to replace your

adapter.

Procedure

Step 1

Connect the USB Adapter to your chosen device.

Step 2

Use a pen or a paper clip to press down the Pairing button on the USB Adapter for four seconds. The blue

LED on top of the adapter blinks when it enters pairing mode.

Step 3

On your headset, slide and hold the Power/Bluetooth switch for two seconds. The adapter and your headset

pair automatically. The LED on top of the adapter shows solid blue when it connects.

Table 2: USB Adapter LED Status

USB LED

The LED shows solid

blue.

The LED flashes blue.

The LED flashes for 10

seconds and turns off.

Adapter Status

The USB Adapter is connected to the headset.

The USB Adapter is in pairing mode.

The USB Adapter can't find a saved headset. Your headset automatically pairs

to the adapter when it turns on and has less than two active Bluetooth connections.

If you have erased all Bluetooth pairings from your headset, put the adapter and

your headset into pairing mode to reconnect them.

Pair the USB Adapter to Your Headset

Your Headset