Cleaning the Air Filters and Vents
Clean the air filters and air intake vents after every 100 hours
of use. If they are not cleaned periodically, they can become
clogged with dust, preventing proper ventilation. This can
cause overheating and damage the projector.
Follow these steps:
1. Turn off the projector and unplug the power cord.
2. To clean the intake vents, Epson recommends using a small
vacuum cleaner designed for computers and other office
equipment. If you don't have one, gently clean the vents
with a soft brush (such as an artist's paintbrush).
3. Gently turn the projector over and remove the filters from
the side and bottom of the projector. Then use a small
vacuum cleaner or soft brush to clean the two filters. Slide
the filters back into place when you're done.
Lower the handle
4. If the dirt is difficult to remove or a filter is broken, replace
the filters as described below. Contact your dealer or call
Epson at (800) 873-7766 in the United States to obtain
new ones. In Canada, please call (800) 463-7766 for dealer
referral.
Slide the filter
up here . . .
. . . and here
Epson PowerLite 7900p Projector
Replacing the Lamp and Air Filters
The life span of the projection lamp is about 2000 hours. It is
time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The message
LAMP REPLACE
the lamp comes on (after about 1900 hours) and the
lamp warning light is flashing orange. To maintain
projector brightness and image quality, replace the lamp as
soon as possible.
The
lamp warning light is flashing red (the lamp is
burnt out).
Contact your dealer or call Epson at (800) 873-7766 in the
United States for a replacement lamp. Request part number
V13H010L22. In Canada, please call (800) 463-7766 for
dealer referral.
Note: When you get a replacement lamp for your projector, new
air filters are included. You should replace the filters when you
replace the lamp. You can check how long the lamp has been in
use (see page 22).
Warning: Let the lamp cool fully before replacing it. In the
unlikely event that the lamp has broken, small glass fragments
may be present and should be removed carefully to avoid injury.
Follow these steps to replace the lamp and air filters:
1. Turn off the projector.
2. When the P power light stops flashing, unplug the power
cord.
3. Let the projector cool for at least half an hour (if it has been
on). The lamp is extremely hot immediately after use.
4. Turn the projector upside-down and remove the air filters
at the side and bottom of the projector.
Lower the
handle
5. Insert the two new air filters. They should click into place.
9/04
Epson PowerLite 7900p Projector
appears on the screen when
Slide the filter
up here . . .
. . . and here
21
-
Sayfayı Yazdır