Siemens XC1001-A Operasyon - Sayfa 10

Kontrol Ünitesi Siemens XC1001-A için çevrimiçi göz atın veya pdf Operasyon indirin. Siemens XC1001-A 32 sayfaları. Extinguishing control unit

Safety

2.3

Standards and directives complied with

Building Technologies

Fire Safety

Disregard of the safety regulations

Before they are delivered, Siemens products are tested to ensure they function

correctly when used properly. Siemens disclaims all liability for damage or injuries

caused by the incorrect application of the instructions or the disregard of danger

warnings contained in the documentation. This applies in particular to the following

damage:

Personal injuries or damage to property caused by improper use and incorrect

application

Personal injuries or damage to property caused by disregarding safety

instructions in the documentation or on the product

Personal injury or damage to property caused by poor maintenance or lack of

maintenance

Disclaimer

We have checked that the content of this document matches the hardware and

software described. Despite this, we cannot rule out deviations and cannot

therefore assume liability for them matching completely. The details in this

document are checked regularly and any corrections needed included in

subsequent editions.

We are grateful for any suggestions for improvement.

A list of the standards and directives complied with is available from your Siemens

contact.

In order to satisfy Directive 89/106/EEC (the Construction Products Directive –

CPD), the firmware of a newly installed fire detection installation must be of at least

the current market package (MP) 2.1.

NOTICE

Firmware version of a newly installed extinguishing installation not

updated

No CPD conformity

Compare the firmware version of a newly installed fire detection installation

with the firmware version for MP2.1

Update the firmware if necessary

A6V10257477_c_en_--

2012-06