Siemens HR678GE 6B Series Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 16

Fırın Siemens HR678GE 6B Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Siemens HR678GE 6B Series 44 sayfaları.

en Steam
Slide the full water tank back into the recess
6.
When doing so, make sure that the water tank clicks
into place in the retainers  ⁠ .
Slowly slide the control panel downwards and then
7.
push it away from you until it is closed completely.
11.2 Types of steam heating
A variety of types of steam heating are available for
which hot steam is used to gently prepare food.
Dough proving
Yeast dough proves considerably more quickly using
this function than at room temperature, and it will not
dry out.
Reheating
The reheating function can be used to warm up food
that has already been cooked, or bread and pastries
from the day before.
Setting the type of steam heating
Note:
Observe the instructions for the types of steam heating:
¡ → "Types of steam heating", Page 16
¡ A cooking time must always be set for steam heat-
ing.
Requirement: The water tank has been filled.
→ "Filling the water tank", Page 15
Press ⁠ .
1.
Press "Steaming".
2.
Use the rotary selector to select the required steam
3.
type of heating.
Press the temperature.
4.
Use the rotary selector to set the temperature.
5.
Press the cooking time.
6.
Use the rotary selector to set the cooking time.
7.
Press
to start the operation.
8.
Note: If the water tank runs dry during operation, a
notification appears in the display. Operation is
stopped.
→ "Filling the water tank", Page 15
a The appliance starts to heat and the time starts to
count down.
a Once the cooking time has elapsed, an audible sig-
nal sounds. The time shown in the display is zero.
Once the cooking time has elapsed:
9.
Press
to silence the audible signal manu-
ally.
To set another cooking time, press the cooking
time and use the rotary selector to set the value.
When the food is ready, press
appliance off.
16
.
Empty the water tank and dry the cooking compart-
10.
ment.
→ "After every steam operation", Page 17
Changing the type of heating
When you change the type of heating, the other set-
tings are also reset.
1.
Press
Press the type of heating.
2.
Turn the rotary selector to select the required type
3.
of heating.
a The corresponding recommended temperature ap-
pears on the display.
Changing the cooking time
You can change the cooking time at any time.
Use the rotary selector to change the cooking time.
a The change is applied immediately.
Changing the temperature
You can change the temperature at any time.
Press the temperature.
1.
Use the rotary selector to change the temperature.
2.
a The change is applied immediately.
11.3 Steam assistance
When you cook with steam assistance, the appliance
introduces steam into the cooking compartment at vari-
ous intervals. This gives your food a crispy crust and a
shiny surface. Meat stays juicy, tender and only under-
goes a minimum reduction in volume.
Suitable types of heating with steam-assisted
cooking
Only certain types of heating are suitable for operation
with steam-assisted cooking.
You can switch on steam assistance for the following
types of heating:
¡ 4D hot air
¡ Top/bottom heating
¡ Circulated air grilling 
¡ Keeping warm
Setting steam-assisted cooking
Requirement: The water tank has been filled.
→ "Filling the water tank", Page 15
Press
1.
In the operating modes menu, set the "Types of
2.
heating".
Use the rotary selector to set the type of heating.
3.
Press the temperature.
4.
Use the rotary selector to set the temperature.
5.
Press the steam injection.
6.
Use the rotary selector to set the steam injection.
7.
Steam injection
Low
Medium
Heavy
Press
8.
to switch the
to pause operation.
⁠ .
to start the operation.