Siemens iQ500 NB535ABS0B Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 32
Fırın Siemens iQ500 NB535ABS0B için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Siemens iQ500 NB535ABS0B 36 sayfaları. Double oven
Ayrıca Siemens iQ500 NB535ABS0B için: Kullanım Kılavuzu (40 sayfalar)
Sayfayı Yazdır
en Installation instructions
¡ Only fit the appliance up to a height which allows
accessories to be easily removed.
¡ The mounting brackets are not required for installing
in a tall unit.
20.6 Corner installation
Observe the installation dimensions and the installation
instructions when installing in a corner.
¡ To ensure that the appliance door can be opened,
you must take the minimum dimensions into consid-
eration when installing in a corner. The dimension
is dependent on the thickness of the unit front and
the handle.
20.7 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
¡ The appliance corresponds to protection class I and
must only be operated with a protective earth con-
nection.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to the local regulations.
¡ The appliance must be disconnected from the
power supply whenever installation work is being
carried out.
¡ Contact protection must be guaranteed by the in-
stallation.
Electrically connecting an appliance without a
protective contact plug
Note: Only licensed specialists may connect the appli-
ance. Damage caused by incorrect connection is not
covered under the warranty.
An isolating switch must be integrated into the perman-
ent electrical installation according to the installation
regulations.
Identify the phase and neutral conductors in the
1.
socket.
The appliance may be damaged if it is not connec-
ted correctly.
2.
Connect the hob in accordance with the connection
diagram.
The yellow/green wire for the safety earth terminal
must be 10 mm longer on the appliance side than
the other wires.
See the rating plate for the voltage.
Connection 3N~ / 2N~ / 1N~: Use a H05VV-F
mains power cable or one with a higher rating.
32
20.8 Installing the appliance in a tall unit
Remove the mounting brackets.
1.
The mounting brackets are not required for installing
in a tall unit.
Tighten the screws for the mounting brackets on the
2.
appliance.
Remove the transport locks on the right and left and
3.
then dispose of them.
The appliance must be transported by two people
4.
using the carry handles on the right and left, while
securing the front of the appliance with one hand.