Siemens IQ 100 Manuel - Sayfa 8
Yıkayıcı Siemens IQ 100 için çevrimiçi göz atın veya pdf Manuel indirin. Siemens IQ 100 8 sayfaları.
Ayrıca Siemens IQ 100 için: Çalıştırma ve Kurulum Talimatı (43 sayfalar), Kurulum ve Kullanım Kılavuzu için Talimatlar (16 sayfalar), Kullanım Kılavuzu (12 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar)
Sayfayı Yazdır
What to do if ...
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
– inicio/pausa (start/pause) not selected?
Detergent not
– Tap not turned on?
dispensed.
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
cannot be opened.
– - - - - (without final spin) selected?
– Can be opened by emergency release only?
Programme does not
– inicio/pausa (start/pause) or
start.
– Washing machine door closed?
– Childproof lock active? Deactivate
Detergent solution is
– - - - - (without final spin) selected?
not drained.
– Clean the detergent solution pump
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Unsatisfactory spin
– Not a fault - the unbalanced-load detection system has cancelled the
result.
spin cycle because of uneven distribution of the laundry. Distribute
Laundry wet/too damp.
small and large items of laundry evenly inside the drum.
– Programme
– Speed selected too low?
The programme
– Not a fault – the programme sequence is optimised for the particular
duration changes
wash process. This may result in changes to the programme
during the wash cycle.
duration in the display field.
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary
products.
Odour formation in the
– Run programme algodón/algodão (cottons) 90 °C without laundry.
washing machine.
Use standard detergent.
activo (wash) display
– Too much detergent used? Mix 1 tablespoon of fabric softener with
lamp flashes. Foam
½ litre of water and pour into dispenser II (not for outdoor and down-
may be coming out of
filled textiles!).
the detergent drawer.
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed? Secure the appliance feet
vibrations and
Installation instructions.
"wandering" during the
– Transportation safety devices removed? Remove the transportation
spin cycle.
safety devices
Noises during spin and
– Clean detergent-solution pump
drain cycles.
Display panel/indicator
– Power cut?
lamps do not function
– Fuses triggered? Reset/change the fuses.
during operation.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence
– Not a fault - unbalanced load detection system adjusts imbalance by
longer than usual.
repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse
cycle.
Detergent residues on
– Occasionally, phosphate-free detergents contain water-insoluble
the laundry.
residues.
– Select
washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to
– Turn off the water supply and call the after-sales service
page 10.
page 3, 4.
page 9.
(finished in) selected?
page 5.
page 3, 4.
page 10.
menos (anti-crease) selected?
page 7.
page 5.
page 9.
Installation instructions.
page 10.
(rinse)/
centrifug. (spin) or brush the laundry after
(off) and remove the mains plug from the socket.
Installation instructions.
Washing machine
WM14E267ES ...
siemens-home.com/welcome
en Washing machine
operating instructions
Observe the safety instructions on page 8.
Read these instructions and the separate installation
instructions before operating the washing machine.
11
Register
your
product
online