Siemens Washing machine Kullanım Kılavuzu - Sayfa 24

Yıkayıcı Siemens Washing machine için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Siemens Washing machine 28 sayfaları. Washing machine
Ayrıca Siemens Washing machine için: Kurulum ve Bakım Talimatları Kılavuzu (10 sayfalar), Kullanım Talimatları Kılavuzu (8 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar), Kullanım Kılavuzu ve Kurulum Talimatları (28 sayfalar), Hızlı Referans Talimatları (2 sayfalar), Hızlı Referans Talimatları (2 sayfalar), Hızlı Referans Talimatları (2 sayfalar), Kullanım Kılavuzu ve Kurulum Talimatları (28 sayfalar), Kullanım Kılavuzu (28 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar), Kullanım Talimatları Kılavuzu (10 sayfalar), Hızlı Referans Talimatları (2 sayfalar), Kullanım Kılavuzu (10 sayfalar), Kullanım Kılavuzu (10 sayfalar)

Sayfayı Yazdır
Siemens Washing machine Kullanım Kılavuzu
en
Fresh water connection
Using the enclosed parts, connect the
fresh water connection to the tap
according to the installation instructions.
Ensure that the fresh water connection is
not kinked, crushed or twisted.
When replacing the appliance, always
connect a new water supply hose to the
water supply. The old supply hose must
not be re-used.
Water pressure:
Minimum 0,05 MPa (0,5 bar) – maximum
1 MPa (10 bar).
If the water pressure is higher, install a
pressure reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water.
If you do use hot water, the temperature
should not exceed 60 °C.

Electrical connection

Connect the appliance only to 230 V
alternating current via a correctly installed
socket with protective conductor.
See rating plate for required fusing
The socket must be attached near the
dishwasher and be freely accessible.
The connection may be modified by an
electrician only.
Use only a residual-current-operated
circuit-breaker which features the
symbol. Only this circuit breaker
guarantees compliance with the currently
valid regulations.
24
Removing the appliance
It is essential, when removing the
appliance, to observe the following
sequence: First, disconnect the appliance
from the power supply.
Pull out the mains plug.
Turn off the water supply.
Disconnect the waste water and fresh
water connections.
Loosen the fastening screws under the
worktop. If fitted, remove the base panel.
Pull out the appliance, carefully pulling the
hose behind.
Transporting the dishwasher
Drain water from the dishwasher. Secure
all loose parts. The appliance should only
be transported in an upright position.
If the appliance is not kept upright
during transport, any water left inside
may seep into the control module and
cause subsequent errors with
programme functions.
Protection from freezing
temperatures
If the appliance is installed in a location
where there is a risk of freezing
.
33
temperatures (e.g. in a holiday home), all
water must be completely drained out of
the interior (see "Transporting the
dishwasher").
Turn OFF the tap, disconnect the supply
hose and allow to drain.