Siemens WU P Series Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 15
Yıkayıcı Siemens WU P Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Siemens WU P Series 40 sayfaları.
Sayfayı Yazdır
Hose and cable lengths
Left-hand connection
■
Right-hand connection
■
*depending on the model
The following are available from
Tip:
specialist dealers/the after-sales
service:
An extension for Aqua-Stop or cold
■
water supply hose (approx. 2.50 m);
order no. WMZ2380, WZ10130,
CZ11350, Z7070X0
A longer supply hose (approx.
■
2.20 m) for standard model
Water inlet
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Notes
Only operate the appliance using
■
cold mains water.
Positioning and connecting
Do not connect the appliance to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
Do not kink or squash the water
■
supply hose.
Do not alter (shorten, cut through)
■
the water supply hose (otherwise its
strength is no longer guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
Optimum water pressure in the supply
network
At least 0.1 MPa (1 bar)
Maximum 1 MPa (10 bar)
Notes
When the tap is open, the water flow
■
rate is at least 8 l/min.
If the water pressure is higher than
■
this, a pressure-reducing valve must
be installed.
Connection
Connect the water supply hose to the
tap (26.4 mm = ¾"):
Turn on the tap carefully,
Note:
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.
en
15