Cisco 7940G Yönetim Kılavuzu - Sayfa 12

IP Telefon Cisco 7940G için çevrimiçi göz atın veya pdf Yönetim Kılavuzu indirin. Cisco 7940G 29 sayfaları. Ios telephony services ip phone
Ayrıca Cisco 7940G için: Kullanıcı Kılavuzu (21 sayfalar), Kullanıcı Kılavuzu (25 sayfalar), Veri Sayfası (7 sayfalar), Manuel (35 sayfalar), Hızlı Referans (2 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Telefon Kılavuzu (17 sayfalar), Yönetici El Kitabı (15 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Referans Kılavuzu (24 sayfalar), Manuel (21 sayfalar), Kurulum Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (10 sayfalar)

Sayfayı Yazdır
Cisco 7940G Yönetim Kılavuzu
Configuring the SIP Parameters Manually
Table 3-1
Parameter
Admin. VLAN Id
Alternate TFTP
Default Router 1 to 5
DHCP Address Released
DHCP Enabled
DNS Servers 1 to 5
Domain Name
Erase Configuration
GARP Enabled
HTTP Proxy Address
HTTP Proxy Port
IP Address
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
3-12
Network Parameters That Can Be Modified
Description
1
Unique identifier of the VLAN to which the phone is attached (for use
in switched networks that are not Cisco networks).
Whether to use an alternate remote TFTP server rather than the local
one.
Valid values are Yes and No. If you set this parameter to Yes, you must
change the IP address in the TFTP server parameter to the address of
the alternate TFTP server. Default is No.
2
IP address (1) of the default gateway used by the phone and (2 to 5) of
the gateways that the phone attempts to use as an alternate gateway if
the default gateway is unavailable.
Whether the IP address of the phone can be released for reuse in the
network.
Valid values are Yes and No. When set to Yes, the phone sends a
DHCP release message to the DHCP server and goes into a release
state. The release state provides enough time to remove the phone
from the network before the phone attempts to acquire another IP
address from the DHCP server. When you move the phone to a new
network segment, first release the DHCP address.
Whether the phone uses DHCP to configure network settings (IP
address, subnet mask, domain name, default router list, DNS server
list, and TFTP address). Valid values are Yes and No. Default is Yes.
To manually configure your IP settings, including the TFTP server's
IP address, set this parameter to No. If not providing the TFTP
server's IP address manually, set DHCP to Yes.
2
IP address of the DNS server used by the phone to resolve names to
IP addresses. The phone attempts to use DNS servers 2 to 5 if DNS
server 1 is unavailable.
Name of the DNS domain in which the phone resides.
Whether to erase all of the locally defined network settings on the
phone and reset the values to the defaults.
Valid values are Yes and No. Yes reenables DHCP. For information on
erasing the local configuration, see the
Network Parameters" section on page
Enables or disables generation of the Gratuitous ARP packets from
the phone.
IP address of the HTTP proxy server. You can use either a dotted IP
address or a DNS name (a record only).
Port number of the outbound proxy port. Default is 80.
2
IP address of the phone that is assigned by DHCP or that is locally
configured.
Chapter 3
Initializing Cisco Unified IP Phones
"Setting and Restoring
3-11.
OL-7890-01