Siemens SF 65T350 Kullanım Kılavuzu - Sayfa 28

Bulaşık Makinesi Siemens SF 65T350 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Siemens SF 65T350 32 sayfaları.

Sayfayı Yazdır

Removing the appliance

It is essential, when removing the

appliance, to observe the following

sequence: First, disconnect the appliance

from the power supply.

Pull out the mains plug.

Turn off the water supply.

Disconnect the waste water and fresh

water connections.

Loosen the fastening screws under the

worktop. If fitted, remove the base panel.

Pull out the appliance, carefully pulling the

hose behind.

Transporting the dishwasher

Drain water from the dishwasher. Secure

all loose parts. The appliance should only

be transported in an upright position.

If the appliance is not kept upright

during transport, any water left inside

may seep into the control module and

cause subsequent errors with

programme functions.

The appliance must be drained in the

following sequence:

Turn on the tap.

Set main switch to ON.

Select the B programme. The

programme duration in minutes is

shown in the numerical display.

Close the door.

Wait for approximately 4 minutes.

Terminate the programme by

pressing A and C

simultaneously.

The time display changes to

Wait a further minute and then

switch the appliance off.

Turn off the tap.

Downloaded from DishWasher-Manual.com Manuals

Protection from freezing

temperatures

If the appliance is installed in a location

where there is a risk of freezing

temperatures (e.g. in a holiday home), all

water must be completely drained out of

the interior (see "Transporting the

dishwasher").

Turn OFF the tap, disconnect the supply

hose and allow to drain.