Siemens SR53M550TI Kullanım Talimatları Kılavuzu - Sayfa 25
Bulaşık Makinesi Siemens SR53M550TI için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Siemens SR53M550TI 46 sayfaları.
Sayfayı Yazdır
1
Operating
the appliance
O p e r a t in g th e a p p l ia n c e
Programme data
The programme data (consumption
values) can be found in the summary of
instructions. They refer to normal
value •:‹.... Different influencing factors
conditions and the water hardness set
such as e.g. water temperature or line
pressure may result in deviations.
A qua sensor *
A q u a s e n s o r
* depending on model
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The Aqua sensor is used according to
the programme. If the Aqua sensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater, the
water is drained and is replaced with
fresh water. In the automatic
programmes the temperature and
running time can also be adjusted to the
degree of soiling.
Switching on the appliance
1. Turn on the tap fully.
2. Switch on ON/OFF switch (.
The Magic Daily programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display )".
3. Press the START button P.
The programme starts running.
Operating the appliance
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )".
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button @ + until the digital
display )" jumps to œ:‹‚.
4. Press @ + or – button until the
displayed time corresponds with your
requirements.
5. Press START button P, timer
programming is activated.
the @ + or – button until )" œ:‹‹
6. To delete timer programming, press
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
value ‹:‹‹ is indicated on the numerical
The programme has ended when the
display )".
en
25