Siemens SX Series Kullanım Talimatları Kılavuzu - Sayfa 26

Bulaşık Makinesi Siemens SX Series için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Siemens SX Series 44 sayfaları. Dishwasher
Ayrıca Siemens SX Series için: İşletim Talimatları (38 sayfalar), Kullanım Talimatları Kılavuzu (38 sayfalar), Kullanım Talimatları Kılavuzu (42 sayfalar), Kullanım Talimatları Kılavuzu (42 sayfalar), Kullanım Talimatları Kılavuzu (44 sayfalar), Kullanım Talimatları Kılavuzu (46 sayfalar), Kullanım Talimatları Kılavuzu (42 sayfalar), Kullanım Kılavuzu (48 sayfalar), Kullanım Talimatları Kılavuzu (40 sayfalar), Kullanım Talimatları Kılavuzu (42 sayfalar), Kullanım Talimatları Kılavuzu (44 sayfalar), Kullanım Talimatları Kılavuzu (40 sayfalar)

Sayfayı Yazdır
Siemens SX Series Kullanım Talimatları Kılavuzu
en
Operating the appliance
3. Hold down programme button #
and press START button `
until •:‹... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes
and the digital display h displays
the factory setting •:‹....
5. Keep pressing programme
button # until the value ˜:‹... is
indicated on the numerical display
h.
To change the setting:
1. Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of ˜:‹ƒ has been
reached, the display jumps back
to ˜:‹‹.
2. Press START button `.
The set value is saved.
3. Close the door.

Switching off the appliance

Short time after the end of the
programme:
1. Open the door.
2. Switch off ON/OFF switch (.
3. Turn off the tap (not applicable if
Aqua-Stop fitted).
4. Remove the utensils when they have
cooled down.
Note
When the programme ends, leave
the appliance to cool down a while
before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.
26

Interrupting the programme

1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
3. To continue the programme, switch
on the ON/OFF switch ( again.
4. Close the door.
T erminating the programme
T e r m i n a t i n g t h e p r o g r a m m e
(Reset)
1. Open the door.
2. Press START button ` for
approx. 3 sec.
The numerical display h indicates
‹:‹‚.
3. Close the door.
The programme sequence lasts
h is indicated ‹:‹‹.
approx. 1 min. On the digital display
4. Open the door.
5. Switch off ON/OFF switch (.
6. Close the door.