Siemens EA6..GF17G Kurulum ve Kullanım Kılavuzu için Talimatlar - Sayfa 7

Hob Siemens EA6..GF17G için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu için Talimatlar indirin. Siemens EA6..GF17G 8 sayfaları.

Installing the hob

Do not trap cables during installation. Push the hob in until it

locks into place.

Worktop cut-out, 500 mm deep:

Mark the centre of the cut-out

Put the hob in place

Align the markings on the hob surround and cut-out

Press in the hob.

The cooker or control unit should be connected to the mains,

but switched off.

Insert the cooker until the socket is accessible.

Screw the PE conductor (green/yellow) for the hob to the

earthing point of the cooker.

Plug in the hotplate connector on the cooker. The colour of

the cable should agree with the colour shown on the label.

The lug N on the plug must point to the left.

Slide the cooker back in. Do not trap the cable while doing this.

Note: Seal the tile joints on tiled work surfaces with silicone

rubber.

Disconnect the appliance from the power supply. Pull out the

cooker a short distance. Pull out the hob connector. Finally

remove the earthing conductor. Push out the hob from below.