Siemens EH8 FF Series Kullanım Kılavuzu - Sayfa 10

Hob Siemens EH8 FF Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Siemens EH8 FF Series 28 sayfaları.
Ayrıca Siemens EH8 FF Series için: Kullanım Bilgileri (20 sayfalar)

Sayfayı Yazdır

Operating the appliance

Residual heat indicator

The hob has a residual heat indicator for each hotplate.

This indicates that a hotplate is still hot. Do not touch a

hotplate while the residual heat indicator is lit up.

The following indicators are shown depending on the

amount of residual heat:

Display

•

: High temperature

■

Display

: Low temperature

■

If you remove the cookware from the hotplate during

cooking, the residual heat indicator and the selected

heat setting will flash alternately.

When the hotplate is switched off, the residual heat

indicator will light up. Even after the hob has been

switched off, the residual heat indicator will stay lit for as

long as the hotplate is still warm.

1Operating the appliance

T his chapter explains how to set a hotplate. The table

O p e r a t i n g t h e a p p l i a n c e

shows heat settings and cooking times for various

meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.

To switch on: Touch the

sounds. The indicator next to the main switch and the

hotplate indicators

light up. The hob is ready to use.

‹

To switch off: Touch the

goes out. All hotplates are switched off. The residual

heat indicator remains lit until the hotplates have cooled

down sufficiently.

Notes

The hob switches off automatically if all hotplates

■

have been switched off for more than 20 seconds.

The selected settings are stored for four seconds

■

after the hob has been switched off. If you switch it

on again during this time, the hob will operate using

the previously stored settings.

Setting the hotplate

The desired power level is set in the programming

panel.

Power level 1 = minimum power.

Power level 9 = maximum power.

Each power level has an intermediate setting. This is

marked with a dot.

Notes

To protect the fragile parts of your appliance from

■

overheating and electrical overloading, the hob may

temporarily reduce the power.

In order to prevent the appliance from producing

■

excess noise, the hob may temporarily reduce the

power.

Selecting a hotplate and heat setting

The hob must be switched on.

Touch the

symbol for the required hotplate.

lights up on the display.

Then select the required heat setting from the

settings range.

The heat setting is set.

symbol. An audible signal

symbol until the indicator