Epson EB-460I Kurulum Kılavuzu - Sayfa 11

Projektör Epson EB-460I için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Epson EB-460I 21 sayfaları.

5. Installation Procedure

Make sure to follow the steps below to install the setting plate. If you ignore these steps, the setting plate

could fall and cause personal injury or property damage.

The maximum combined mass of the setting plate and the projector is approximately 15.2 kg

(33.5 lb). When you install the setting plate, calculate the permissible weight, carefully check

the construction, material, and strength of the wall, and perform the installation properly using

the most appropriate method.

(1) Determine the template sheet position.

• From the projection distance table, confirm the screen size (S) and the distance between the

projection surface and wall plate (b).

• Align the CTR line (vertical) of the template sheet with the center line (vertical) of the projection

surface.

Confirm where the beams are within the wall, and shift the position left or right as necessary.

(The position can be shifted horizontally left or right from the center line of the projection surface by

up to 45 mm [1.77 in.].)

Align the

line (horizontal) of the template with the height of (b).

CTR line of template sheet

line of template sheet

(2) Attach the template sheet to the wall.

65 mm (2.55 in.)

Center line of projection surface