Cisco Cisco 7940 Kurulum ve Yapılandırma Kılavuzu - Sayfa 5

Preparation

After the firmware and configuration files are installed on the UC server and the DHCP server is

configured, the next step is connecting the phones to the network and waiting for the initial boot. The

initial boot may take a long time to complete if firmware upgrades occur. While this upgrade is

happening, do not unplug the phone.

After the phone firmware is upgraded and rebooted and the phone is in an idle state, make sure that the

phone is running the correct firmware and has been automatically detected by the UC server.

To verify the firmware:

1. From the Cisco phone, select Settings > Status.

2. Scroll down and select Firmware Versions.

3. Examine Application Load ID. It should read P0S3-08-9-00.

If the firmware version listed on the phone does not match the above value, consult the

troubleshooting section at the end of this document.

To verify automatic detection:

1. Launch the UC client: select Start > All Programs > UC Client.

2. Log in using the admin authentication or using an authentication with admin profile access.

3. In the Administration menu, select Phones.

4. Sort by the medium access control (MAC) address column and search for the MAC address of the

Cisco phone that you connected to the network. The phone's MAC address is printed on the

underside of the phone.

If the phone does not appear in the list, consult the troubleshooting section at the end of this

document.

Adding an Identity

You must either have an unused identity that you can add to the phone, or you must create a new

identity/user to associate with the phone. For more information about creating users and identities in the

UC server, refer to the NetVanta UC Server Administrator Guide–Enterprise Communications Edition,

available online at

http://kb.adtran.com/.