Digital Matter Sting Başlarken - Sayfa 4

GPS Digital Matter Sting için çevrimiçi göz atın veya pdf Başlarken indirin. Digital Matter Sting 4 sayfaları.

Digital Matter

8. DEVICE INSTALLATION

The Sting is an ultra-compact GPS tracking device and can be placed anywhere. When placing

the Sting, consider the following:

1. Protect the device from water ingress – the device is not IP rated.

2. Minimise the chances of the device being accidentally crushed or dislodged.

3. Maximise the GPS and mobile reception, and provide adequate ventilation.

4. Position the light pipe for adequate exposure to tamper indications.

5. Allow the device to sense required temperature and humidity changes in its

environment.

6. Minimise temperature exposure outside of the battery's specifications.

Since the Sting is a battery powered device, reception is critical to its performance. While other

members of the DM product family rely on their high-quality GPS receivers for enhanced

accuracy and the ability to operate in very low signal, the primary concern for the Sting is the

battery used during each GPS fix.

If possible, choose a mounting point that will not result in elevated temperatures. For instance,

mounting the Sting in direct sunlight on the dash of an unventilated cabin may cook the battery,

leading to abnormally short service life.

9. CHARGING THE BATTERY

The Sting is a rechargeable GPS tracking device. To charge the Sting, plug the USB cable into

any 5V 500mA USB charger. Plug the Micro-USB plug into the Sting. The red LED will come on

while the Sting is charging. The LED will switch off when charging is complete.

Warning: The Sting will prevent charging outside of the charging temperature specifications

(0-40°). It is recommended that charging is done at room temperature or around 25°C.

10. APN SETUP VIA SMS

If the APN for the SIM is not in the AutoAPN list, it must be set by SMS. To do this:

1. Send an SMS from any phone to the cell phone number (MSISDN) of the SIM card.

2. Use the following format for the APN text message:

#*,APN,<apn_name>,<username>,<password>

3. If the <username> and <password> are blank or not required then you can leave them

off.

4. You can also reset a device to use auto-APN by sending a blank APN: #*,APN

Example with username and password: #*,APN,myAPN,joebloggs,secret123

Example without username and password: #*,APN,myAPN

Sting Getting Started

All information provided in this document is subject to legal disclaimers

Revision 1.0 - 3 July 2017

Sting Getting Started

Page 4 of 4