Epson EB-L30002U Kurulum El Kitabı - Sayfa 8

Projektör Epson EB-L30002U için çevrimiçi göz atın veya pdf Kurulum El Kitabı indirin. Epson EB-L30002U 16 sayfaları.
Ayrıca Epson EB-L30002U için: Manuel (17 sayfalar)

Sayfayı Yazdır
Epson EB-L30002U Kurulum El Kitabı
Transport and Installation Handbook
When installing the projector in an environment in which a high-powered
laser beam is being used, make sure it is installed so that the laser beam
does not hit the surface of the projector's projection lens or the built-in
camera.
If the laser beams through the surface of the projection lens or the built-in camera, block the
laser beam with non-permeable or incombustible aluminum foil or metal plates such as iron
to protect the projection lens and the built-in camera. You can also use the projector's Shutter
function to prevent the LCD panel from being damaged by laser light.
When using the projector in smoky environments such as at events and so
on, make sure you replace the air filter after approximately 240 hours of
use. (This is a guideline when using the projector in an environment with
an atmospheric concentration of ondina oil of approximately
0.000000013%. The air filter replacement time may be shorter depending
on the operating environment.)
Using the projector in a smoky environment may cause the filter's dust collection function
to decline and dust may adhere to the inside of the projector or the power supply; this may
cause a malfunction to occur.
Do not install the projector in an airtight location.
Heat exhausted from the projector will become trapped in the location which could cause
the projector to malfunction. When the projector is installed in an enclosed location so that
it cannot be seen, make sure the location is not airtight and that it can be ventilated and the
temperature can be controlled.

Notes on Installing

The projector can be installed at any angle. There is no vertical or horizontal limit to how the projector can
be installed.
You can install the projector in a portrait orientation by attaching the carrying handles to the top and bottom
of the projector. You can remove the feet from the projector and attach them to the carrying handle.
Caution
7