Cisco SPA302D Kullanıcı Kılavuzu - Sayfa 10

IP Telefon Cisco SPA302D için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cisco SPA302D 10 sayfaları. Mobility enhanced cordless handset
Ayrıca Cisco SPA302D için: Kullanıcı Kılavuzu (38 sayfalar), Veri Sayfası (7 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Kullanıcı El Kitabı (49 sayfalar)

Note 1: To verify that the handset is registered to the base station, confirm that the DECT signal strength icon is

solid (not flashing) and that the handset ID, such as Handset 1 (or Handset 2), appears near the top right corner

of the display screen.

Note2: In case that the batteries are removed from the handset or go dead, the handset will still be registered on

the base station.

7.0 Upgrade the SPA 302D handset software

It is possible to manually upgrade the handset to the latest software version. Software upgrades are performed

"over the air" and the Cisco SPA232D does not have an external interface requiring a physical connection to

another device.



From the Settings menu choose Update Software and then, at the Check for software update prompt press

Confirm.



Within a moment, the handset displays the current version of software on the handset and the latest software

version available from the Cisco SPA232D. Press the Select soft key.



Place the handset in the charging cradle (Important: Do not remove the handset from the charging cradle

during the upgrade. Do not power off the handset, charging cradle, or base station, or otherwise interrupt the

upgrade process).



The handset erases the flash memory, downloads the new software and verifies the upgrade data. After the

upgrade, a message appears indicating the status of the upgrade (for example, if the upgrade succeeded).

Press Reset to reboot the handset.



Note 1: If the upgrade fails, press Reset to reboot the handset. Check the status lights on the Cisco SPA232D

to make sure the unit is powered on and functioning. Repeat the upgrade.



Note 2: If the handset has a software version less than 2.55 (i.e. either 2.40 or 2.50) this process needs to be

manually performed by the end user. In subsequent firmware releases and if the handset already has the

2.62 firmware version installed, it will be able to upgrade its software version automatically once it is

associated with the base station.

Cisco SPA302D and SPA232D full user guide v1.0