Ricoh RDC-5000 Manuel - Sayfa 5

Dijital Kamera Ricoh RDC-5000 için çevrimiçi göz atın veya pdf Manuel indirin. Ricoh RDC-5000 28 sayfaları. Ricoh rdc-5000: user guide
Ayrıca Ricoh RDC-5000 için: Başlarken (14 sayfalar)

Sayfayı Yazdır

Changing Flash Modes

This section explains how to change the flash mode. Switch the flash mode to meet

your photographic needs.

Flash Modes

The mode screen will change in the following sequence as you switch the flash mode:

Flash Off Mode

1 2

1 8 0 0 x 1 2 0 0

* The factory default setting is flash off mode.

• When you shoot a subject located closer than about 0.4 m (15.8 inches)

Important

Note

with the flash activated, the light from the flash may appear red in the

resultant shot. The subject may also appear white due to over-exposure.

To avoid these problems, switch the camera to flash off mode.

• The flash will not fire in text mode or continuous shooting mode.

Note

• The flash will not fire in the following white balance modes: cloudy (overcast),

daylight, fluorescent light, and tungsten light.

• Enable the keep settings mode to save the flash mode setting. See "Keep

settings" (p.106).

• When shooting a subject with the flash activated, if the subject appears

dark on the LCD monitor, zoom to a wider angle. The subject may be difficult

to focus on with the telephoto setting.

• Shooting in red-eye reduction mode will reduce red eyes appearing in the

resultant picture. See "Redeye Reduction Mode" (p.72).

Effective Range of the Flash

When you shoot in daylight with the flash activated (daylight synchro photography),

the flash has an effective range of about 0.4 to 3.0 m (1.3 ft to 9.9 ft) for the

telephoto setting and 0.4 to 3.4 m (1.3 ft to 11.2 ft) for the wide-angle setting.

The subject will appear dark in the picture if the light from the flash fails to reach

it.

Auto Mode

Forced Flash Mode

1 2

1 8 0 0 x 1 2 0 0

Slow synchro Mode

1 2

1 8 0 0 x 1 2 0 0

1 2