Ricoh MP C6003 Manuel - Sayfa 30

Fotokopi Makinesi Ricoh MP C6003 için çevrimiçi göz atın veya pdf Manuel indirin. Ricoh MP C6003 44 sayfaları. Envelope printing, setup & printing
Ayrıca Ricoh MP C6003 için: Broşür ve Teknik Özellikler (12 sayfalar), Kullanıcı Kılavuzu (36 sayfalar), İşlev Kurulum Kılavuzu (5 sayfalar), Yönetici El Kitabı (48 sayfalar), Eğitim Çalışması (4 sayfalar)

3. Other Information for This Machine

nanometer wavelength for each emitter. The beam divergence angle is 16 degrees (minimum) and 23

degrees (maximum) in the vertical direction, and 7 degrees (minimum) and 12 degrees (maximum) in

the horizontal direction, and laser beams are generated in Continuous Wave (CW) mode. Each 4ch-

LDA has four light sources and the maximum output power of the light source is 17 milliwatt.

Caution:

Use of controls or adjustments or performance of procedures other than those specified in the manuals

might result in hazardous radiation exposure.

Notes to USA Users of FCC Requirements

Part 15 of the FCC Rules

Declaration of Conformity

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Responsible party: Ricoh Americas Corporation

Address: 5 Dedrick Place, West Caldwell, NJ 07006

Telephone number: 973-882-2000

Product Name: Multi Function Peripheral

Model Number:

• Type 1: MP C3003SP/MP C3003SPG

• Type 2: MP C3503SP/MP C3503SPG

• Type 3: MP C4503SP/MP C4503SPG

• Type 4: MP C5503SP/MP C5503SPG

• Type 5: MP C6003SP/MP C6003SPG

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off