Ricoh 7000 Kurulum Kılavuzu - Sayfa 4

Yazıcı Aksesuarları Ricoh 7000 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Ricoh 7000 4 sayfaları. Duplex unit for machine code: g080

Lower the external tray toward you.

Installing the Duplex Feed Unit

Slowly open the front cover by pulling on the two areas on

the left and right.

Slowly open the waste oil bottle in the direction of the

arrow.

Holding the duplex feed unit using both hands, place it on

the vertical rail, and then slide it slowly in until it stops.

The vertical rail is in the position, as shown.

ZHXH280J

ZDJH007J

ZHXH150J

ZHXH290J

ZHXH300J

Fasten the duplex feed unit using a short screw and the

provided screwdriver.

Be sure to return the provided screwdriver to its original

position on the inside of the front cover.

This completes installation of the duplex feed unit.

Slowly push back the waste oil bottle in the direction of

the arrow.

Slowly close the front cover by pressing the two areas on

the left and right.

Note

After finishing the installation, you can check the duplex unit is

installed properly: Print the configuration page from the "List/Test

Print" menu. If it is installed properly, you will see "Duplex Unit"

appear in the "Options" list. (G080)

If the duplex unit is not installed properly, repeat the procedure

from step

. If you cannot install it properly even after

reinstallation, contact your sales or service representative.

Check for leftover parts. You will not need these.

Printed in China

ZHXH310J

ZHXH160J

ZDJH041J

ZHXH011N

G348-8600