Cisco 12006 series Değiştirme Talimatları Kılavuzu - Sayfa 33

Ağ Yönlendiricisi Cisco 12006 series için çevrimiçi göz atın veya pdf Değiştirme Talimatları Kılavuzu indirin. Cisco 12006 series 44 sayfaları. Chassis replacement instructions
Ayrıca Cisco 12006 series için: Ambalajdan Çıkarma Talimatları Kılavuzu (16 sayfalar), Veri Sayfası (9 sayfalar)

Sayfayı Yazdır
Figure 19
1
2
3
Step 6
Visually check the LEDs on the two alarm cards. (See
correctly, the following LED conditions should be true.
LEDs that normally should be off:
•
•
•
•
LEDs that normally should be on:
•
•
•
Step 7
On the console terminal, verify that the console displays the system banner and that the system and all
interfaces initialize successfully.
If the power modules do not power up, or if the system or any interfaces do not initialize properly, see
Chapter 4, "Troubleshooting the Installation" in the Cisco 12006 and Cisco 12406 Router Installation
and Configuration Guide. If you are still unable to resolve the problem, contact your Cisco service
representative for assistance.

Packaging the Replaced Chassis for Shipment

To repackage the chassis to return it to the factory, follow these steps:
Use the anchor clips, angle brackets, bolts, and screws you removed when you unpacked the replacement
Step 1
chassis to fasten the defective chassis to the shipping pallet base. (See
78-16109-01
Alarm Card LEDs On/Off Conditions
FAIL
ENABLED
0
1
0
1
2
1
2
3
MBus status LED
CSC status LEDs (two)
SFC status LEDs (three)
One MBUS status LED labeled FAIL
Two CSC status LEDs labeled FAIL
Three SFC status LEDs labeled FAIL
Three router alarm LEDs labeled CRITICAL, MAJOR, MINOR
One MBUS status LED labeled ENABLED
Two CSC status LEDs labeled ENABLED
Three SFC status LEDs labeled ENABLED
ALARM
4
5 6
4
Critical alarm LED
5
Major alarm LED
6
Minor alarm LED
Figure
Cisco 12006 and Cisco 12406 Router Chassis Replacement Instructions
19.) When the system is operating
Figure
1.)
33