Cisco 1401 Hızlı Başlangıç Kılavuzu - Sayfa 5

Ağ Yönlendiricisi Cisco 1401 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 1401 8 sayfaları.

Install the Router (continued)

C. Connect a PC to the router

To use Cisco IOS software to conﬁgure the router, it must be connected to a terminal or to a

PC with terminal-emulation software. Terminal emulation software should be conﬁgured with

the following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit.

Take the following steps to connect the router to one of these devices:

Step 1

Connect one end of the light-blue console cable (included) to the CONSOLE port on

the router rear panel.

Step 2

Depending on the console port connector (DB-25 or DB-9) on your terminal or PC,

connect one of the gray adapters (included) to the other end of the console cable.

Step 3

Connect the gray adapter to the DB-25 or DB-9 connector on your terminal or PC.

FLASH PC CARD

Cisc o 1401

CONSO LE

LNK

ATM 25

ETHER NET

Light blue

console cable

To PC or terminal