Cisco 1700 series Yapılandırma - Sayfa 9

Ağ Yönlendiricisi Cisco 1700 series için çevrimiçi göz atın veya pdf Yapılandırma indirin. Cisco 1700 series 34 sayfaları. Secure firewall management center
Ayrıca Cisco 1700 series için: Mevzuata Uygunluk ve Güvenlik Bilgileri Kılavuzu (45 sayfalar), Manuel (15 sayfalar), Yapılandırma Kılavuzu (25 sayfalar), Uygulama Notu (41 sayfalar), Donanım Sorun Giderme (12 sayfalar), Genel Bakış Kılavuzu (13 sayfalar), Manuel (5 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar), Donanım Kurulum Kılavuzu (46 sayfalar)

Sayfayı Yazdır

Before you begin, disconnect all WAN cables from the router to keep it from running the AutoInstall

process. The router tries to run AutoInstall whenever you power it on if there is a WAN connection on

both ends and the router does not have a valid configuration file stored in NVRAM (for instance, when

you add a new interface). It can take several minutes for the router to determine that AutoInstall is not

connected to a remote Transmission Control Protocol/Internet Protocol (TCP/IP) host.

To enter configuration mode, follow this procedure:

Step 1

Connect a console to the router. If you need instructions for connecting a console, refer to the

installation chapter of your router installation and configuration guide. Power up the router.

Step 2

If the current configuration is no longer valid, after about one minute you see the following prompt:

Would you like to enter the initial dialog? [yes]:

Enter no. You now enter the normal operating mode of the router.

Note

After a few seconds, you see the user EXEC prompt. Type enable and the password to enter enable

Step 3

mode:

Router> enable

Password:

Configuration changes can be made only in enable mode. The prompt changes to the privileged EXEC

(enable) prompt (

Router#

Enter the config terminal command to enter configuration mode:

Step 4

Router# config terminal

Router(config)#

The router enters global configuration mode, indicated by the

If you have not configured the router before or want to change the configuration, you can configure

Step 5

global parameters, passwords, network management, and routing protocols. In this example, IP routing,

AppleTalk routing, and Internetwork Packet Exchange (IPX) routing are all enabled:

Router(config)# ip routing

Router(config)# appletalk routing

Router(config)# ipx routing

For complete information about global configuration commands, refer to the IOS configuration guides

and command references.

Select the ADSL interface to configure:

Step 6

Router(config)# interface atm 0

Router(config-if)#

The prompt changes again to show that you are in interface configuration mode.

Note

Select the ADSL operating mode:

Step 7

OL-3317-03

If the current configuration is valid, you enter the normal operating mode automatically.

Router#

For the Cisco 1751 and 1760 routers, enter the command as interface atm slot/port. For

example, interface atm 0/0.

Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers

Configuring the ADSL Interface

prompt.

Router(config)#