Cisco 1751 Hızlı Başlangıç Kılavuzu - Sayfa 29

Ağ Yönlendiricisi Cisco 1751 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 1751 35 sayfaları. Modular access router
Ayrıca Cisco 1751 için: Çözüme Genel Bakış (16 sayfalar), Veri Sayfası (19 sayfalar)

Sayfayı Yazdır
Cisco 1751 Hızlı Başlangıç Kılavuzu
Configuring Frame Relay for VoIP
Configuring VoIP on a Frame Relay link involves certain special considerations to ensure acceptable
voice quality. For Frame Relay links with slow output rates (64 kbps or less) and with data and voice
being transmitted over the same permanent virtual circuit (PVC), you should configure the following
parameters:
•
Note
Lowering the MTU size affects data throughput speed.
•
•
Router(config-if)# frame-relay ip rtp header-compression
•
For further information and more detailed examples of Frame Relay configuration, refer to the
Cisco 1751 Router Voice-over-IP Configuration Guide.
When you finish configuring the router, you must save the new configuration to nonvolatile RAM
Note
(NVRAM) by copying
the configuration process. Refer to the
78-11259-05
Lower maximum transmission unit (MTU) size—Voice packets are generally small. If you decrease
the MTU size to 300 bytes, large data packets can be broken up into smaller data packets that are
more easily interleaved with voice packets.
The following example configures an MTU size of 300 bytes over serial interface 0/0:
Router# interface serial 0/0
Router(config-if)# mtu 300
RSVP—Configure RSVP on the subinterfaces (which correspond to PVCs) to reserve bandwidth for
voice channels. Refer to the section on
The following example configures RSVP over serial subinterface 0/0.1:
Router(config-if)# interface serial 0/0.1 point-to-point
Router(config-if)# ip address 192.168.19.0 255.0.0.0
Router(config-if)# ip rsvp bandwidth 48 48
RTP header compression—Configure RTP header compression on the subinterfaces to minimize the
size of the voice packet. Refer to the section on
The following command configures RTP header compression on the selected subinterface:
Traffic shaping—Use traffic shaping to control the outbound traffic rate; otherwise, voice packets
can be discarded. In Cisco IOS Release 12.0T, Frame Relay traffic shaping is not compatible with
RSVP. Use generic traffic shaping instead, and set the committed information rate (CIR) equal to
the port speed. This prevents the router from exceeding the CIR rate and discarding the frames.
The following command configures generic traffic shaping with a CIR of 32000 bps:
Router(config-if)# traffic-shape rate 32000
running-config to startup-config
"RSVP"
earlier in this guide.
"RTP Header
. You should also save periodically during
"Saving the Configuration" section on page 13
Cisco 1751 Voice-over-IP Quick Start Guide
Configuring Voice-over-IP
Compression" earlier in this guide.
for details.
29