Cisco 2504 Başlangıç Kılavuzu - Sayfa 29

Ağ Yönlendiricisi Cisco 2504 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco 2504 47 sayfaları. Wireless controller
Ayrıca Cisco 2504 için: Kullanıcı Kılavuzu (11 sayfalar)

Sayfayı Yazdır

With Release 7.4, directly connected local mode APs via two PoE (Power over Ethernet) ports are

Note

supported. Directly connected APs were not supported before Release 7.4.

You have prepared the controller for basic operation. Refer to the

Configuration Guide

wireless network.

Figure 14

Checking the Controller LEDs

If your 2504 controller is not working properly, check the LEDs on the front panel of the unit. You can

use the LED indications to quickly assess the status of the unit. See

of the front panel LEDs.

The installation is complete. Refer to the Cisco Wireless Controller Configuration Guide for more

information about configuring your controller. The guide is available on cisco.com.

Using the Reset Button

The Reset button on the front panel of the controller becomes active after the controller boots. To reset

the controller using the Reset button, follow these steps:

Connect a PC to the controller console point.

Step 1

Press and hold the Reset button for at least 3 seconds using a pointed object, such as a ball point pen,

Step 2

pencil, or paper clip.

for information on configuring the controller to meet the specific needs of your

Access Points Connected to a Controller

Cisco 2504 Wireless

Controller

Cisco Access Points

Cisco 2500 Series Wireless Controller Getting Started Guide

Cisco Wireless Controller

Network

10/100/1000BASE-T

MDI cable

Network

10/100/1000BASE-T

MDI cables

Table 1 on page 4

Connecting to the Network

for a description