Cisco 2524 - Router - EN Yapılandırma Kılavuzu - Sayfa 6
Ağ Yönlendiricisi Cisco 2524 - Router - EN için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Cisco 2524 - Router - EN 23 sayfaları. Troubleshooting guide
Ayrıca Cisco 2524 - Router - EN için: Yapılandırma Kılavuzu (23 sayfalar), Genel Bakış (10 sayfalar), Kuruluma Hazırlanıyor (19 sayfalar), Sorun Giderme Kılavuzu (4 sayfalar)
Sayfayı Yazdır
Configuring the Router
At any time during the System Configuration Dialog, you can request help by typing a
question mark (?) at a prompt.
Before proceeding with the System Configuration Dialog, obtain from your system
administrator the node addresses and the number of bits in the subnet field (if applicable)
of the Ethernet and synchronous serial ports. For more information about Internet Protocol
(IP) addresses and subnets, refer to the publication Internetworking Technology Overview.
(See the section "Getting More Information" at the end of this chapter.)
Take the following steps to configure the router using the System Configuration Dialog:
Step 1
Note
2 stop bits.
Step 2
Note
you selected. The screen displays in this section are for reference only and may not exactly
reflect the screen displays on your console.
4-6 Cisco 2524 and Cisco 2525 Router User Guide
Connect a console terminal to the console connector on the rear panel of your
router, and turn ON power to the router. (For more information, refer to the section
"Connecting the Console Terminal and Modem" in the chapter "Installing the
Cisco 2524 and Cisco 2525 Routers.")
The default parameters for the console port are 9600 baud, 8 data bits, no parity, and
After about 30 seconds, information similar to the following is displayed on the
console screen.
The messages displayed vary, depending on the Cisco IOS release and feature set
When you see this information, you have successfully booted your router:
System Bootstrap, Version X.X(XXXX) [XXXXX XX], RELEASE SOFTWARE
Copyright (c) 1986-1992 by Cisco Systems
2500 processor with 4096 Kbytes of main memory
Notice: NVRAM invalid, possibly due to write erase.
F3: 5797928+162396+258800 at 0x3000060