Cisco 2600 Series Konfigürasyon - Sayfa 12

Ağ Yönlendiricisi Cisco 2600 Series için çevrimiçi göz atın veya pdf Konfigürasyon indirin. Cisco 2600 Series 15 sayfaları. Configuring adsl wic to support pppoe clients
Ayrıca Cisco 2600 Series için: Kurulum Kılavuzu (12 sayfalar), Sürüm Notları (32 sayfalar), Uygulama Notu (41 sayfalar), Veri Sayfası (6 sayfalar), Ekler (15 sayfalar), Kurulum Kılavuzu (22 sayfalar), Genel Bakış (13 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Manuel (5 sayfalar)

Sayfayı Yazdır

ip ospf transmit-delay seconds

ip ospf priority number

ip ospf hello-interval seconds

ip ospf dead-interval seconds

ip ospf authentication-key password

2.2.5 Configure OSPF authentication

Cisco router supports message-digest hashing algorithm to guarantee the integrity of

OSPF packets and authenticate between the routers. The key is set on interface by the

following command

Router(config-if)#ip

The key-id is an identifier and takes the value in the range of 1 through 255.The

encryption type field refers to the type of encryption, where 0 means none and 7 means

proprietary. The key is an alphanumeric password up to sixteen characters. Neighbor

routers must use the same key identifier with the same key value.

After the key is configured, authentication must be enabled in global configuration

mode

Router(config)#router ospf process-id

Router(config-router)#area area-id authentication message-

2.2.6 No Form

To turn off any feature of OSPF routing, for example to turn off network 10.12.0.4

255.255.255.252 area 0, give the next command:

Router(config-router)#no network 10.12.0.4 255.255.255.252

area 0

To turn off RIP, use the no router rip command:

Router(config)#no router ospf process-id

Set the estimated number of seconds it

takes to transmit a link state update packet

on an OSPF interface.

Set router priority to help determine the

OSPF designated router for a network.

Specify the length of time, in seconds,

between the hello packets that a router

sends on an OSPF interface.

Set the number of seconds that a router's

hello packets must not have been seen

before its neighbors declare the OSPF

router down.

Assign a specific password to be used by

neighboring OSPF routers on a network

segment that is using OSPF's simple

password authentication.

ospf

message-digest-key

encryption-type key

digest

key-id

md5