Cisco 2801 - Integrated Services Router Kullanıcı Kılavuzu - Sayfa 22

Ağ Yönlendiricisi Cisco 2801 - Integrated Services Router için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cisco 2801 - Integrated Services Router 29 sayfaları. 2800 series integrated services routers
Ayrıca Cisco 2801 - Integrated Services Router için: Veri Sayfası (20 sayfalar), Hızlı Başlangıç Kılavuzu (47 sayfalar)

Cisco 2801 - Integrated Services Router Kullanıcı Kılavuzu

Related Documentation

IPSec Requirements and Cryptographic Algorithms

Protocols
SNMP v3 over a secure IPSec tunnel may be employed for authenticated, secure SNMP gets and sets.
Since SNMP v2C uses community strings for authentication, only gets are allowed under SNMP v2C.
SSL is not an approved protocol, and shall not be used in FIPS mode of operations

Remote Access

Related Documentation
For more information about the Cisco 1841 and Cisco 2801 Integrated Services Routers, refer to the
following documents:
Cisco 1841 Integrated Services Router with AIM-VPN/BPII-Plus and Cisco 2801 Integrated Services Router with AIM-VPN/EPII-Plus
22
The only type of key management protocol that is allowed in FIPS mode is Internet Key Exchange
(IKE), although manual creation of security associations is also permitted.
Although the IOS implementation of IKE allows a number of algorithms, only the following
algorithms are allowed in a FIPS 140-2 configuration:
ah-sha-hmac
esp-des
esp-sha-hmac
esp-3des
esp-aes
The following algorithms are not FIPS approved and should not be used during FIPS-approved
mode:
MD-5 for signing
MD-5 HMAC
RSA
Telnet access to the module is only allowed via a secure IPSec tunnel between the remote system
and the module. The Crypto officer must configure the module so that any remote connections via
telnet are secured through IPSec, using FIPS-approved algorithms. Note that all users must still
authenticate after remote access is granted.
SSH access to the module is only allowed if SSH is configured to use a FIPS-approved algorithm.
The Crypto officer must configure the module so that SSH uses only FIPS-approved algorithms.
Note that all users must still authenticate after remote access is granted.
Cisco 1800 Series Integrated Services Routers Quick Start Guides
Cisco 1800 Series Hardware Installation documents
Cisco 1800 Series Software Configuration documents
Cisco 1800 Series Cards and Modules
OL-8719-01