Cisco 7505 Değiştirme Talimatları Kılavuzu - Sayfa 12

Ağ Yönlendiricisi Cisco 7505 için çevrimiçi göz atın veya pdf Değiştirme Talimatları Kılavuzu indirin. Cisco 7505 23 sayfaları. 600w ac-input power supply and fan tray replacement
Ayrıca Cisco 7505 için: Kurulum Talimatları Kılavuzu (15 sayfalar), Hızlı Başlangıç Kılavuzu (32 sayfalar), Değiştirme Talimatları Kılavuzu (18 sayfalar)

Replacing the Chassis

Figure 6

Installing the Cable Management Brackets

The cable management brackets help to keep network interface cables untangled and orderly, and

prevent cables from hindering access to interface processors in the lower interface processor slots.

The brackets attach to the inner sides of the chassis at the interface processor end. Six M3 x 8-mm,

Phillips panhead screws, which are included with the brackets, secure the brackets to the chassis

(three per bracket). Figure 7 shows the interface processor end of the chassis with the brackets

installed.

Note

referred to as the chassis.

Install the brackets on the new chassis ﬁrst, before you begin moving system components from the

old chassis. If you install the brackets after you move the interface processors and connect the

interface cables, you might have to disconnect the cables to install the screws that secure the

brackets. Route interface cables through the cable management brackets as you connect them to the

interface processor ports (or as you install interface processors that still have interface cables

connected to them). Wrap cable ties through the holes provided to secure small-gauge cables.

12 Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Installing the Chassis in a Standard Four-Post, 19-Inch Equipment Rack

Chassis front

For this procedure, the Cisco 7010 and Cisco 7505 chassis are functionally the same, and are