C3 Custom Coolers ROVER Kullanıcı El Kitabı - Sayfa 10
Dondurucu C3 Custom Coolers ROVER için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. C3 Custom Coolers ROVER 16 sayfaları. Remote control cooler
Ayrıca C3 Custom Coolers ROVER için: Hızlı Başlangıç Kılavuzları (2 sayfalar)
Sayfayı Yazdır
Use
Charging the battery
1.
Locate battery charger
2.
Plug round end of charger into charging port on back of cooler
3.
Plug pronged end of charger into a standard 120V wall outlet
•
Do not use an extension cord
4.
Charge cooler for 12 hours to ensure a full charge
5.
After charging is complete, unplug charger from wall and cooler
Re-Charging Interval and Time
•
On average, returning battery to a full charge will take 10 - 12 hours. Failure
to charge battery as directed could cause permanent damage to battery and
void warranty. Damage to battery may occur if allowed to drain completely.
Do not allow battery to drain completely.
•
Check battery charger and charging port for wear and damage prior to
charging. Do not charge battery if damage has occurred. Only use the
provided 12V rechargeable battery and charger.
Battery Storage
•
Store battery where temperatures are between -10°F and 75°F. Store on a
wood surface. Do not store battery on cement floors, as this will result in
battery discharge. Wipe battery clean with a dry cloth prior to storage.
Charge battery at least once per month.
Battery Replacement and Disposal
1.
Remove back control panel cover from cooler, cut white zip ties, pull out old
battery and disconnect the red and black wires from the battery.
2.
Use the double-sided tape included with replacement battery and place
two strips on the bottom of the replacement battery.
3.
With the replacement battery outside of cooler, attach red and black wires to
the top of the new battery, reference the red and black markings on the terminals.
4.
Place new battery inside cooler on tray, pressing firmly to adhere double-
sided tape to tray.
5.
Using (2) zip ties included with replacement battery, secure zip ties around
battery and tray on both sides, cut excess tie length.
6.
Replace control panel cover to the cooler and charge battery (12) hours to
ensure full charge.
7.
Follow local battery disposal statutes & codes in disposal of battery waste.
10