ACDelco I-7005T Kullanıcı El Kitabı - Sayfa 9

Akü Şarj Cihazı ACDelco I-7005T için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. ACDelco I-7005T 15 sayfaları. Fully automatic microprocessor controlled battery charger for 12-volt lead acid batteries

Sayfayı Yazdır

• ON / OFF key - When AC power cord

is plugged into the AC outlet, the digital

indicator should display the term 'OFF'.

Press and release the 'ON/OFF' key to cycle

the system to display the term 'ON'.

When 'ON' is displayed, the charger is

ready to respond to the following key

commands.

• Select key - This key allows the user to

select the charge rate appropriate for the

battery to be charged. The user can select

2, 6, 10, 12, & 15 charge rates.

Press once for the display to show '2A',

indicating a 2 amp charge will begin in about

1 second.

You may press the key again at any time to

select a higher charge rate.

The charger will display 'FUL' till the battery

is fully charged. Following, the charger will

go into maintenance mode automatically

to warm up the battery from discharging

and maintain a full charge. During this

mode when battery is unable to take any

charge, the charger will shut off and wake

up to continue the charge till the battery

discharges to pre-determined low level.

However, never exceed the battery

m a n u f a c t u r e r ' s

recommendation.

Charge rates can be determined by

checking with the battery manufacturer.

Many times that information is part of the

equipment manufacturer's owners manual

or battery label.

OPERATION

c h a r g e

r a t e

• Volt./Bat.% key - Press once and the

indicator will display a 3 character voltage

measurement; i.e. 13.4, 15.5, etc.

Press the key again and it will display the

% charge of the battery. To get an accurate

percent (%) charge reading, you should

let the battery set for 20 minutes in a 'no

charge' condition in order to remove any

surface charge that has accumulated.

You may use the Volt./Bat.% key at any time

except during the Maintenance charge cycle

and Reinforced Activation cycle.

NOTE: Detecting a rapidly charging voltage

battery could generate an inaccurate

result.

The Battery capacity% shown in the charging

process is the charging Battery capacity%

and usually not precise with inconsistent

values due to so-called 'surface charge'.

For more accurate reading after charging

process is disconnected, the surface charge

should be removed by temporarily creating

a load on the battery, such as by turning on

lights or other accessories.

The Battery capacity% displayed is an

estimated value, not precise diagnosis and

getting less precise due to battery conditions

such as aging, sulfated plates, internal open

cell and shorted cell.