Acdeos AXS MD SA Series Yoğunlaştırılmış Kılavuz - Sayfa 5
Otomobil Aksesuarları Acdeos AXS MD SA Series için çevrimiçi göz atın veya pdf Yoğunlaştırılmış Kılavuz indirin. Acdeos AXS MD SA Series 13 sayfaları.
Sayfayı Yazdır
4
Installation
The installation must only be done by a company that is familiar with bodybuilding or modifying
vehicles, and that have the trained technical staff.
4.1
Mechanical Installation
Below instruction is based at mounting the step with the optional flexi fit mounting kit which is
available under number S130 01 024. Ask your dealer for availability
In order to mount the step you do not need to make any major vehicle adaptations. The step
is placed under the floor in the middle of the front, middle or rear door. Chassis modifications
are not needed, but you may need to remove some plastic underbody parts.
Exact measurements of the product should be taken from the official installation drawings. Ask
Acdeos for the last revision and official installation drawing. Figures and drawings in this
manual are only indicative.
Installation:
Create a safe working environment. Raise the vehicle to the appropriate working height.
Identify the location underneath the
vehicle where the step will be mounted.
Ensure the cassette can be mounted in
the required position without being
obstructed by the chassis or other
vehicle parts.
Make sure that the step is not too
close to hot parts such as the
exhaust system. This can damage the
step.
The picture shows the basic principles
for mounting the step.
Identify where the 4 front mounting bolts will go. The holes for this
fixation should be drilled in the lower flange of the outer chassis bar of
the vehicle. Drill the holes ø6.5
mm. Always protect all drilled
holes with zinc spray. Make
sure there is enough material in
the flange under the hole. Place
the step with two bolts at the
flange and support it at the rear.
Take the flexible mounting
brackets supplied with the step.
These
brackets
mounted in several ways. The
brackets should be used to fix
the rear side of the step to the bottom of the vehicle. It is recommended
that a sturdy section of the vehicle floor us used. Mount the brackets so
that they bridge the gap between step and vehicle floor / chassis. The
M8 studs should be placed as vertical as possible. This fixing requires
some technical knowledge and own interpretation.
can
be
5