Ace 3003530 (AC-6168) Kullanıcı Kılavuzu - Sayfa 3

Aksesuarlar Ace 3003530 (AC-6168) için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ace 3003530 (AC-6168) 8 sayfaları. Wireless door sensor chime

Sayfayı Yazdır

Note: Most installations will not require you to change any of the jump-

ers on your doorbell.

WARNING: Disconnect chime unit from power source before opening

code access door. Close door and replace screw before reconnecting

to power.

The transmitter and chime communicate by using a code that can be changed

by removing and/or adding jumpers on both the transmitter and chime. The

code is factory set; however, there are 128 selectable codes that allow you

to expand your system and prevent outside interference. Another wireless

doorbell system or other wireless products may cause interference and the

system may not function properly. Follow the instructions below for setting a

new code.

1. Disconnect the power to the transmitter and chime.

2. Open the cases and locate the jumpers on both the transmitter and chime

(See illustration).

3. The transmitter and chime both have eight different jumper locations. The

jumper positions 1 through 7 are used for setting the code.

4. To change the code, add and/or remove jumpers as needed. There are

128 different combinations. It is recommended to only change one jumper

at a time and then check to see if system is functioning properly. Note:

Jumpers in positions 1 through 7 must be exactly the same for both the

transmitter and chime for this system to function.

598-1073-02

Code and Tune Settings

Code Settings

-3-