Ace 3035748 Kullanıcı El Kitabı - Sayfa 3

Aksesuarlar Ace 3035748 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Ace 3035748 13 sayfaları. Wireless chime accessory receiver

Inside Chime

Chime does not sound:

• Make sure push button and chime codes are the same (See pages 2 and 3).

• Check orientation of push button battery (See page 3).

• Check charge of push button and chime batteries, replace if necessary.

Batteries seem OK, but the chime does not work when installed:

• Do not mount chime or push button on metal or near metal studs. This

reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to

move chime or push button off metal surface.

• Concrete floors may reduce range. Move chime away from floor.

• Try locating chime closer to push button.

The range of the wireless chime can vary with location, temperature and bat-

tery condition.

ACE

reserves the right to discontinue and to change specifications at any time

without notice without incurring any obligation to incorporate new features in

previously sold products.

598-1075-03

Push Button Battery Replacement

Install an alkaline type A23 12 Volt battery. The

positive terminal should be positioned as shown.

Tune Setting

(Not used on

all models)

Note: Some models might require the use of

tweezers to remove and replace the jumpers.

Troubleshooting

Inside Push

Button

-3-

* Code Settings 1-7

Must Match Both

Push Button and

Chime

Tune

Setting