CAB 5314 Operatör El Kitabı - Sayfa 10

Etiket makinesi CAB 5314 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. CAB 5314 17 sayfaları. Vacuum-belt applicator

Operation

3.3

Mounting

Fig.5

Mounting

To clean the applicator and printer it's sometimes necessary to turn away or even dismount the applicator from the

printer.

Do not adjust the setting screws, throttle valves or other alignment elements. This will enable use of the applicator

directly after cleaning.

1 Pull out the locking bolt (3) and put the base plate (2) into the opening (1).

2 Let the locking bolt (3) snap into the holes (4).

3 It may be necessary to lay the printer on its side or back to gain access to the bottom of it.

4 Put the hole of mounting plate (9) over the pin (3).

5 Connect SUB-D 9 male connector (8) to the female connector (6) of the printer.

6 Swing the applicator to the printer and turn in the screw (10) loosely.

7 The holes in the mounting plate (13) must be aligned to the holes in the printer base plate (11).

8 Place the screws (12) and tightening them.

9 Tighten screw (10).

Attention!

Initiation, adjustments and changing of parts is to be performed by qualified service personnel only.

 Initiation/Service Manual Applicator

Attention!

 Disconnect the printer and applicator from the power supply before mounting the applicator!

 Ensure the printer is in a stable position!