Cisco Unified Communications Manager 8.5(1) Hızlı Başlangıç Kılavuzu - Sayfa 18
Ağ Yönlendiricisi Cisco Unified Communications Manager 8.5(1) için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco Unified Communications Manager 8.5(1) 20 sayfaları. 850 series and 870 series access routers cabling and setup
Ayrıca Cisco Unified Communications Manager 8.5(1) için: Veri Sayfası (8 sayfalar)
Sayfayı Yazdır
- 1. Table of Contents
- 2. Cisco One-Year Limited Hardware Warranty Terms
- 3. Locate the Product Serial Number
- 4. Before Installation
- 5. Connect the Antenna to the Wireless Router (Optional)
- 6. Connect the Power-Over-Ethernet Module to the Cisco 870 Series Router (Optional)
- 7. Typical Installations of the Cisco 850 Series and Cisco 870 Series Routers
- 7. Console Port
- 7. Power Adapter
- 8. Connect the Router
- 9. Install SDM and Configure the Router
- 10. Related Documentation
- 11. Obtaining Documentation and Submitting a Service Request
Chapter 1
Install SDM and Configure the Router
Step 13
Install SDM and Configure the Router
Step 1
Step 2
Step 3
Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide
1-18
Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide
For Cisco 857, Cisco 876, Cisco 877, and Cisco 878 routers, the DSL line
Note
must have been provisioned by your service provider and must be
correctly configured. Check the carrier detect (CD) status on the ADSL
CD LED or G.SHDSL CD LED on the router. If the ADSL CD LED or
G.SHDSL CD LED does not light up, check with your service provider.
If you have connected a PoE module to the router, connect the PoE module power
supply to the input jack on the back panel of the PoE module. The green LED on
the PoE front panel lights up and power is provided to devices connected to the
PoE.
See the Cisco 870 Series Routers Hardware Installation Guide for detailed
connection instructions.
To install Cisco SDM for configuring the router, follow these steps:
Connect a PC to any router LAN port, as shown in
Figure
1-9.
Insert the Cisco SDM software CD into the CD drive of the PC. An installation
wizard is launched from the CD. Install Cisco SDM by following the instructions
on the installation wizard user interface.
Use Cisco SDM to configure the router by following the instructions in the
Cisco Router and Security Device Manager (SDM) Quick Start Guide.
Figure
1-7,
Figure 1-8
78-16262-04
and