Cisco WS-X45-SUP6-E - Supervisor Engine 6-E Kurulum ve Yapılandırma Notu - Sayfa 14
Ağ Yönlendiricisi Cisco WS-X45-SUP6-E - Supervisor Engine 6-E için çevrimiçi göz atın veya pdf Kurulum ve Yapılandırma Notu indirin. Cisco WS-X45-SUP6-E - Supervisor Engine 6-E 30 sayfaları.
Sayfayı Yazdır
Removing the Supervisor Engine
Installing the Supervisor Engine
Catalyst 4500 series and Catalyst 4500 E-series switches have horizontal chassis slots that are numbered
from top to bottom. On the Catalyst 4503, 4503-E, Catalyst 4506, and 4506-E switches, you can install
the supervisor engine only in slot 1. On the Catalyst 4507R or 4510R switch, you install the primary
supervisor engine in slot 1, and you can install an optional redundant supervisor engine in slot 2. On the
Catalyst 4507R-E switch, you install the primary supervisor engine in slot 3, and you can install an
optional redundant supervisor engine in slot 4. On the Catalyst 4510R-E switch, you install the primary
supervisor engine in slot 5, and you can install an optional redundant supervisor engine in slot 6. The
supervisors in a redundant system must be of the same type.
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing. Statement 1034
To prevent ESD damage, handle supervisor engines by the carrier edges only.
Caution
To install a supervisor engine in a Catalyst 4500 E-series switch, follow this procedure:
Take the necessary precautions to prevent ESD damage as described in the installation guide for your
Step 1
switch.
Step 2
Ensure that you have enough clearance to accommodate any interface equipment that you will connect
directly to the supervisor engine ports.
Step 3
Loosen the captive installation screws that secure the switching-module filler plate or the existing
supervisor engine (whichever is present) and remove it.
Remove the supervisor engine filler plate or the existing supervisor engine from slot 1. If a switching
Step 4
module filler plate was installed, save it for future use. If you are removing an existing supervisor engine,
see the
To install the new supervisor engine, grasp the switching module front panel with one hand and place
Step 5
your other hand under the carrier to support the supervisor engine, as shown in
the printed circuit boards or connector pins.
Align the edges of the supervisor engine carrier with the slot guides on the sides of the switch chassis,
Step 6
as shown in
Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E
14
"Removing the Supervisor Engine" section on page
Figure
2.
16.
Figure
2. Do not touch
78-18337-01