Cisco 1700 series Manuel

Kablosuz Erişim Noktası Cisco 1700 series için çevrimiçi göz atın veya pdf Manuel indirin. Cisco 1700 series 15 sayfaları. Secure firewall management center
Ayrıca Cisco 1700 series için: Mevzuata Uygunluk ve Güvenlik Bilgileri Kılavuzu (45 sayfalar), Yapılandırma Kılavuzu (25 sayfalar), Uygulama Notu (41 sayfalar), Donanım Sorun Giderme (12 sayfalar), Genel Bakış Kılavuzu (13 sayfalar), Yapılandırma (34 sayfalar), Manuel (5 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar), Donanım Kurulum Kılavuzu (46 sayfalar)

ROM Monitor

This appendix describes the Cisco router ROM monitor (also called the bootstrap

program). The ROM monitor firmware runs when the router is powered up or

reset. The firmware helps to initialize the processor hardware and boot the

operating system software. You can perform certain configuration tasks, such as

recovering a lost password or downloading software over the console port, by

using the ROM monitor. If there is no Cisco IOS software image loaded on the

router, the ROM monitor runs the router.

This appendix contains the following sections:

Entering the ROM Monitor

To use the ROM monitor, you must be using a terminal or PC that is connected to

the router by means of the console port. Refer to the installation chapter in the

Hardware Installation Guide for your router, for information about connecting the

router to a PC or terminal.

78-5407-03

Entering the ROM Monitor

•

ROM Monitor Commands

•

Command Descriptions

•

Disaster Recovery with TFTP Download

•

Configuration Register

•

Console Download

•

A P P E N D I X

Cisco 1700 Series Router Software Configuration Guide

B-1