Cisco 2800 Series Konfigürasyon - Sayfa 7

Kablosuz Erişim Noktası Cisco 2800 Series için çevrimiçi göz atın veya pdf Konfigürasyon indirin. Cisco 2800 Series 10 sayfaları. Cisco ios software configuration
Ayrıca Cisco 2800 Series için: Hızlı Başlangıç Kılavuzu (13 sayfalar), Veri Sayfası (8 sayfalar), Hızlı Başlangıç Kılavuzu (47 sayfalar), Uygulama Notu (41 sayfalar), Hızlı Başlangıç Kılavuzu (45 sayfalar), Genel Bakış (27 sayfalar), Veri Sayfası (5 sayfalar), Veri Sayfası (20 sayfalar), Yapılandırma (32 sayfalar)

Sayfayı Yazdır

FastEthernet0/1

Select one of the available interfaces for connecting the router to the management network:

Step 8

Enter interface name used to connect to the

management network from the above interface summary: fastethernet0/0

Respond to the following prompts as appropriate for your network:

Step 9

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: no

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 16 subnet bits; mask is /16

The configuration is displayed:

The following configuration command script was created:

hostname Router

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

no ip routing

interface FastEthernet0/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.1.2.3 255.255.0.0

interface FastEthernet0/1

shutdown

no ip address

end

Respond to the following prompts. Select [2] to save the initial configuration:

Step 10

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started!

The user prompt appears.

Router>

Verify the initial configuration. See the

Step 11

verification procedures.

OL-5788-01

unassigned

unset

"Verifying the Initial Configuration" section on page 9

Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers

Configuring the Router

dow

for