Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Hızlı Başlangıç Kılavuzu - Sayfa 19

Kablosuz Erişim Noktası Cisco AIR-AP1020 - 1000 Series Lightweight Access Point için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco AIR-AP1020 - 1000 Series Lightweight Access Point 44 sayfaları. Aironet 1000 series ieee 802.11a/b/g lightweight access points with external antennas

Sayfayı Yazdır
Installation and Configuration

Configuration Setup

Figure 5
Does My Cisco Aironet 1000 Series Lightweight Access Point Qualify for this Procedure?
Does My Cisco Aironet 1000 Series Lightweight Access Point Qualify for this Procedure?
•
Configuration Steps for a Cisco 1000 Series Lightweight Access Point
1.
2.
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
Configuration Setup
Configuring controller
Layer 2 and 3 devices
Access points
If your 3.0 or later version Cisco Aironet 1000 Series lightweight access point(s) cannot be
configured for any reason using the following procedure, refer to the
Assistance" section.
Configure the Internet Software Consortium (ISC) V3.0pl1 DHCP Server to provide the
vendor-specific Option 43 using the following entries:
option controller code 43 = text;
option controller "<Switch IP Address>";
in which <Switch IP Address> is the IP address of the Cisco Wireless LAN Controller you
are going to use to prepare the Cisco Aironet 1000 Series lightweight access point, or which can be
a comma-delimited string of Cisco Wireless LAN Controller IP addresses.
(These commands direct all discovery messages for unconfigured Cisco Aironet 1000 Series
802.11a/b/g lightweight access points to the configuring Cisco Wireless LAN Controller.)
Be sure the configuring Cisco Wireless LAN Controller is in LWAPP Layer 3 Mode (use the CLI
command show switchconfig to determine the mode; if it is set to Layer 3, use the CLI
command config switchconfig mode L2 to change it to Layer 2). Be sure that the
configuring Cisco Wireless LAN Controller is in the same Controller Mobility Group as the planned
Primary, Secondary, and Tertiary Cisco Wireless LAN Controllers, and that the configuring Cisco
Wireless LAN Controller DS Port is connected to the network.
Pre-Installation Configuration
Primary controller
DHCP server
"Obtaining Technical
9