Argent Edo ED10SF0401 Kurulum Talimatları - Sayfa 2

İç Mekan Mobilyaları Argent Edo ED10SF0401 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Argent Edo ED10SF0401 2 sayfaları. Floor mounted

Sayfayı Yazdır
INSPECT THE FURNITURE TO
ENSURE NO DAMAGE HAS
OCCURRED DURING TRANSIT.
IF DAMAGE HAS OCCURRED,
OR VISIBLE DEFECTS EXIST,
DO NOT PROCEED WITH
INSTALLATION AND ADVISE
ARGENT IMMEDIATELY.
F U R N I T U R E M U S T B E
FITTED THROUGH STUDS
INTO THE WALL. USE FIXING
BRACKETS PROVIDED.
IF STUD POSITIONING DOES
NOT ALIGN WITH FIXING
BRACKETS, CABINET MUST
BE ADDITIONALLY SECURED
THROUGH THE BACK BOARD
TO STUDS. IF NO STUDS
ARE FOUND TO SECURE
THROUGH, NOGGINS MAY BE
REQUIRED.
PRIOR TO INSTALLATION
Argent recommends a qualified trade
person fit your vanity. Ensure your
furniture is installed to relevant building
codes and Australian Standards.
Please note, Argent will not be liable
for the cost of installation or removal
of the furniture and the warranty will be
voided if damage occurred during or
after installation.
Fit Wall hung basin at required height
to secure stud or frame, ensure level.
Fit plumbing.
Hold vanity over pipes in correct position.
(1)
Open door and remove shelf.
Remove kicker if needed.
(2)
Locate adjustable feet
and adjust
by turning until the bottom of the vanity
is at least 5mm from the floor.
2
3
1
2
4
C
1
Ensure door is adjusted to
sit square as they may have
moved during transportation.
MEASURE & MARK
(3)
Find
in wall studs to secure to. Measure and mark
position for drilling. Fix through a stud where possible.
If no studs are found to secure through, special fixings
may be required. Use fixings appropriate to your wall
material.
FIT OFF, ADJUST & FINISH
C
Drill securing screws appropriate to your wall through
furniture back board in stud and wall.
Ensure door is adjusted to sit square as it may have
moved during transportation. Replace shelf, ensure all
square with the installed vanity.
Put a bead of waterproof mastic compound around the
back edge of the basin and where the basin touches the
wall. Do not over tighten the basin bolts, to avoid
damaging the basin.
Door Adjustment
Adjustment
Adjustment
Feet Adjustment
Adjustment
Basin Sealing
I MP OR TA N T:
U S E ON LY b a th ro o m
g rad e si l i co n s ea l an t
Epoxy type glues
MUST NOT BE USED.
Put a bead of waterproof mastic
compound around the back
edge of the basin and where the
basin touches the wall. Do not
tighten the basin bolts to avoid
damaging the basin.
I M P OR TA N T:
INSPECT THE FURNITURE
TO ENSURE NO DAMAGE
HAS OCCURRED DURING
TRANSIT.
IF DAMAGE HAS
OCCURRED, OR VISIBLE
DEFECTS EXIST, DO
NOT PROCEED WITH
INSTALLATION AND ADVISE
ARGENT IMMEDIATELY.