DigitaLinx DL-HD70 Hızlı Kurulum Kılavuzu - Sayfa 6
Genişletici DigitaLinx DL-HD70 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. DigitaLinx DL-HD70 8 sayfaları.
Ayrıca DigitaLinx DL-HD70 için: Kurulum Kılavuzu (2 sayfalar)
Sayfayı Yazdır
HDBaseT Cabling
To ensure proper performance of the DL-HD70, it is recommended that you use solid core,
shielded Category 6 F/UTP cabling at a minimum. Category 5e F/UTP may perform well but
may not support power over HDBaseT reliably.
For opti mized HDBaseT performance use the following Liberty Wire and Cable branded
cabling;
Category 6 plenum; 24-4P-P-L6SH
Category 6A plenum; 24-4P-P-L6ASH
Category 6 NON-plenum; 24-4P-L6SH
Category 6A NON -plenum; 24-4P-L6ASH
1
8
Cabling Requirements
When using shielded category cabling ALWAYS...
....use shielded connectors
....properly ground the category cable
TIA/EIA-568B
P n 1
Or n e/Wh te
P n 2
Or n e
P n 3
Green/Wh te
P n 4
Blue
P n 5
Blue/Wh te
P n 6
Green
P n 7
Brown/Wh te
P n 8
Brown
Twisted Pair Wiring
Use TIA/EIA-568B wiring for Category 6
connecti on between send and receive
units.
RS232 Wiring
Connect the controller or device RX signal
to TX on the DL-HD70 extender. Connect the
controller or device TX signal to Rx on the
DL-HD70 extender.