DigitaLinx DL-UHDRC70 Hızlı Kurulum Kılavuzu - Sayfa 5
Genişletici DigitaLinx DL-UHDRC70 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. DigitaLinx DL-UHDRC70 8 sayfaları. Hdbaset extender
Ayrıca DigitaLinx DL-UHDRC70 için: Hızlı Kurulum Kılavuzu (8 sayfalar), Kullanıcı El Kitabı (16 sayfalar), Hızlı Kurulum Kılavuzu (6 sayfalar)
Sayfayı Yazdır
1. Verify all components included are present before installati on.
2. Connect an HDMI source device to the HDMI IN port on the transmitt er using an
HDMI cable
3. Connect a display device to the HDMI OUT port on the receiver using an HDMI
cable
4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between
the transmitt er and the receiver. TIA/EIA-568B straight-through wiring connecti ons
must be used with the DL-UHDRC70
5. Connect control system and devices to the RS232 port on the transmitt er and
receiver for serial pass through.
6. Both the transmitt er and receiver has an IR IN and an IR OUT for bi-directi onal
IR control. Connect one device with an IR emitt er to the IR OUT then the other
device should be connected with an IR eye into IR IN to pass IR control
7. Apply power to DL-UHDRC70 by connecti ng the 18V power supply to either the
transmitt er or receiver. Powering one unit will power the other via PoC
Note: On the front panel of the TX/RX check to make sure the Power, Status,
HDCP & Link lights are all illuminated on both units. This will indicate a successful
connecti on with a lit HDCP light illustrati ng the presence of encrypti on within the signal.
Power and Link are stati c lights and Status should be blinking.
Connecti vity Instructi ons
DL-UHDRC70 Quick Guide