Cisco Catalyst IW6300 Series Başlarken - Sayfa 11

Kablosuz Erişim Noktası Cisco Catalyst IW6300 Series için çevrimiçi göz atın veya pdf Başlarken indirin. Cisco Catalyst IW6300 Series 20 sayfaları. Product document of compliance
Ayrıca Cisco Catalyst IW6300 Series için: Kurulum Kılavuzu (28 sayfalar)

Sayfayı Yazdır

Getting Started and Product Document of Compliance for the Cisco Catalyst IW6300 Heavy Duty Series Access Points

Antennas

The data sheet lists the antennas that can be used by Cisco Catalyst IW6300 Heavy Duty Series Access Points. All

antennas where assessed together with the equipment against the requirements of the R&TTE directive.

Depending on the country a different regulatory limit might be applicable. It is therefore the responsibility of the end user

to select a power level that, together with the antenna, results in an eirp (radiated power) level that is below the applicable

limit.

Note: Antenna caps must be installed when an antenna is not in use (maximum torque range: 6.2-9.7 in-lbs).

Antennas installed within a hazardous locations environment must be passive only, rated IP66/67 and compliant to

IEC 60079-0.

Avoidance of Electrostatic Discharge

In order to prevent an electro static discharge within a hazardous location, only touch with an insulating object or use

means to continuously drain off electrostatic charges in the installation.

Performing Maintenance

The access point requires minimal periodic or preventive maintenance as it has no moving parts, filters, lubricants, or

mechanical contact components. However, when installed in a hazardous location, periodic inspections should be

conducted in order to ensure that the access point is operating satisfactory. This section provides information about

performing maintenance on an access point installed in a hazardous location.

Removing the Access Point from Service

When removing an access point from service, make sure you remove power from the access point before opening the

cover and disconnecting the power input wiring. When removing the AC wiring, remember that the ground connection

should be the last to be disconnected.

Conducting Periodic Inspections

The access point should be inspected periodically to ensure normal and airtight operation in the hazardous location

environment.

Inspection Routine

Inspect O-ring seals and exterior electrical connections for aging, corrosion, and low

ground resistance.

Inspect cover and liquid-tight adapter gaskets for airtightness.

Periodicity

Every 3 years

Every 5 years